Olympus E-300 Manuel d'utilisateur Page 180

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 211
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 179
11
Appendix
The camera's power is
turned off.
The USB driver was not
successfully installed.
The camera's PC MODE
is set to CONTROL.
Set the power switch to ON.
Install the OLYMPUS Master.
Set PC MODE to AUTO or STORAGE. When
AUTO is set, the selection screen for USB
connection is displayed every time you connect
the USB cable to the camera.
P. 158
P. 132
180
If you encounter problems
Possible cause Corrective action
Ref. Page
The top left part of the picture appears too bright.
When shooting at slow
shutter speeds, noise may
be generated due to a rise
in temperature in the CCD
drive circuit.
Set NOISE REDUCTION to ON before taking
pictures.
P. 105
Pictures are not stored on
the card.
The card error occurs.
NO PICTURE appears on the monitor. Record
pictures.
Refer to “Error codes”.
P. 174
The video cable is not
connected correctly.
The camera's video
output signal is incorrect.
The TV 's video signal is
incorrect.
Connect the cable properly according to the
instructions.
Set the video signal according to the region
where used.
Set the TV to the video input mode.
P. 116
P. 134
Adjust the brightness of the monitor using the
menu.
Block the sunlight with your hand.
P. 131
The brightness is not
adjusted properly.
The monitor is exposed to
direct sunlight.
The computer does not recognize the camera correctly.
No picture is displayed on the TV when connected to the camera.
Pictures cannot be played back on the monitor.
The monitor is hard to see.
11E-300EN-P171 04.10.22 11:38 AM Page 180
Vue de la page 179
1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 210 211

Commentaires sur ces manuels

Pas de commentaire