Olympus C-750 Manuel d'utilisateur télécharger pdf (Page 89)

Remote control shooting

Advanced shooting

TIPS

The self-timer/remote control lamp does not blink after pressing

the shutter button on the remote control device.

Æ The remote control device may be too far from the camera. Move

closer to the camera and press the shutter button on the remote

control device again.

Æ There is signal interference. Change the channel as described in

the remote control device’s instruction manual.

How to operate the zoom using the remote control device.

Æ Point the remote control device at the remote control receiver on

the camera. For zooming, press the W or T button on the remote

control device. During operation, the self-timer/remote control lamp

blinks.

How to cancel the remote control mode.

Æ The remote control mode is not canceled automatically after

shooting. Perform step 2 and set the mode to OFF.

• If the remote control receiver is exposed to strong light, the effective

signal distance may be reduced or shooting may not take place.

• To shoot sequential shots using the remote control device, press

and hold the shutter button on the remote control device. If the

camera does not receive the remote control signal properly,

sequential shooting may stop.

• Read the remote control device’s instruction manual for information

on playback by remote control device.

Note

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 237 238

Pas de commentaire

Olympus C-750 Manuel d'utilisateur Page 89