Olympus Tough TG-810 Manuel d'utilisateur Page 44

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 43
44
EN
For information on using the menus, see “Setup menu” (p. 6).
Using an external ash [Remote Flash]
Using an external ash [Remote Flash]
J (Shooting menu 2) X Remote Flash
Submenu 2 Application
Off The external ash is not available.
#RC
An Olympus Wireless RC Flash
System compatible ash is used
for taking pictures. (Channel: CH1,
Group: A)
Slave
The commercially-available slave
ash that is synchronized with the
camera ash is used for taking
pictures. The ash intensity setting
can be adjusted.
Taking pictures with the Olympus
Wireless RC Flash System
You can take pictures with a wireless ash when using
a ash compatible with the Olympus Wireless RC Flash
System. This enables multi- ash photography using
multiple ash units compatible with this system. The
camera’s built-in ash is used for communication between
the camera and ash.
For details about operation of a wireless ash, refer
to the instruction manual for the special external
ash.
1
Set the wireless ash based on the guidelines
below.
Wireless ash setup range guidelines
The setup range varies depending on the ambient
environment.
10m
30°
30°
5m
50°
50°
50°
50°
30°
30°
Point the remote
sensor toward the
camera
Flash direction
2
Turn on the wireless ash.
3
Use the MODE button on the wireless ash to
set to RC mode, and make the channel and
group settings. (Channel: CH1, Group: A)
4
Set [Remote Flash] (p. 44) on the camera
to [#RC], and set the channel to the same
setting as the wireless ash.
5
Select the ash mode.
“Using the ash” (p. 35)
6
Take a test shot to check the operation of the
ash and the resulting image.
Be sure to check the charge level of the camera and
wireless ash before taking pictures.
Although there is no limit on the number of wireless
ash units that are set up, usage of a maximum of
three units is recommended to prevent malfunction
due to interference with each other.
When the camera ash is set to [#RC], the camera
built-in ash is used for communication with the
wireless ash. It cannot used for taking pictures.
Vue de la page 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 91 92

Commentaires sur ces manuels

Pas de commentaire