Olympus DS-2000 Manuel d'utilisateur Page 40

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 39
40
Troubleshooting
Troubleshooting
Probable cause
The batteries are not loaded properly.
The batteries are dead.
The POWER/LOCK switch is set to OFF.
If none of these suggestions works
The recorder is in HOLD mode.
The SmartMedia card is not formatted.
The batteries are dead.
The SmartMedia card has a write-protect seal
attached to it.
The SmartMedia card is unformatted.
The SmartMedia card does not have enough memory.
The maximum number of files has been reached.
The earphone is connected.
The VOLUME control is set to 0.
The file is locked.
The SmartMedia card has a write-protect seal
attached to it.
The recorder was shaken during recording.
The recorder was placed near a cell phone or
fluorescent lamp while recording or during playback.
The microphone sensitivity is too low.
The maximum number of index marks (16) has been
reached.
The SmartMedia card has a write-protect seal
attached to it.
The file is locked.
A non-standard AC adapter is being used.
The POWER/LOCK switch is set to ON.
Symptom
Nothing
appears on
the display
Wont start
Unable to
record
No playback
tone heard
Unable to
erase
Noise heard
during
playback
Recording
level too low
Unable to set
index marks
Wont work
with AC
adapter
Unable to
eject the
SmartMedia
card
Action
Verify polarity is correct.
Replace with new batteries.
Set the POWER/LOCK switch to
ON.
Reset the recorder ( P.36).
Release the recorder from HOLD
( P.36).
Format the SmartMedia card
( P.34).
Replace with new batteries.
Remove the seal.
Format the SmartMedia card.
Erase unnecessary files or insert
another SmartMedia card.
Check another folder.
Disconnect the earphone jack.
Adjust the VOLUME control.
Unlock the file ( P.27).
Remove the seal.
Move the recorder.
Set the microphone sensitivity to
CONF mode and try again.
Erase unnecessary index marks
( P.26).
Remove the seal.
Unlock the file ( P.27).
Use the Olympus A321 (for US,
Canada) or A322 (for Europe
except U.K) AC adapter
(Oprional).
Set the POWER/LOCK switch to
OFF.
Vue de la page 39
1 2 ... 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire